Installing a PEX compression fitting is a straightforward process, but it requires attention to detail to ensure a secure and leak-free connection. Here’s a step-by-step guide:
1. Prepare the PEX Pipe
- Cut the PEX Pipe: Use a pipe cutter or a sharp utility knife to make a clean, straight cut on the PEX pipe. The cut must be square (90-degree angle) to ensure a proper seal.
- Remove Any Burrs: After cutting, check the edge of the pipe for any burrs or rough spots. Use a deburring tool or a knife to smooth the edges if necessary.
2. Insert the Compression Sleeve
- Slide the Compression Sleeve: Take the compression sleeve (the small metal ring) and slide it onto the PEX pipe. Position it about 1/2 inch from the end of the pipe. The sleeve will help secure the fitting and create a tight seal.
- Ensure Correct Positioning: Make sure the sleeve is placed correctly on the pipe. If the sleeve is positioned too far from the fitting or too close, it could result in an improper seal.
3. Insert the PEX Pipe into the Compression Fitting
- Push the Pipe Into the Fitting: Insert the end of the PEX pipe into the compression fitting (the fitting could be a straight connector, elbow, or tee, depending on your application).
- Ensure Full Insertion: Push the pipe all the way into the fitting until it reaches the fitting’s stop or shoulder. The pipe should be securely in place before proceeding.
4. Slide the Compression Nut onto the Pipe
- Position the Compression Nut: Slide the compression nut over the end of the pipe and onto the threaded portion of the compression fitting.
- Ensure Alignment: Make sure the nut is aligned with the fitting’s threads and the pipe is fully inserted into the fitting.
5. Tighten the Compression Nut
- Hand-Tighten the Nut First: Begin by hand-tightening the compression nut onto the fitting. This will hold the pipe and the compression sleeve in place.
- Use a Wrench: Once the nut is hand-tight, use an adjustable wrench to tighten it further. Turn the nut clockwise until it is snug, but avoid over-tightening. You should feel resistance when the nut is tight enough to create a proper seal. Be cautious not to overtighten, as this could damage the fitting or cause it to leak.
6. Check the Connection
- Inspect the Fitting: Ensure the compression nut is securely fastened and the sleeve is firmly in place against the pipe.
- Test for Leaks: After installation, turn on the water supply and check the fitting for any leaks. If there are any, tighten the compression nut slightly more.
7. Final Adjustments
- Recheck the Fitting: If there is still a leak, double-check the alignment of the compression sleeve and pipe. Sometimes slight repositioning can fix a minor leak.
- Ensure Proper Pressure: Verify that the connection can withstand the pressure of the system. If needed, check for any signs of stress or wear in the fitting over time.
Tips for a Successful Installation
- Use Proper Tools: Make sure you’re using a pipe cutter designed for PEX pipes to ensure a clean, straight cut.
- Don’t Over-Tighten: Over-tightening the compression nut can damage the fitting or the pipe, leading to leaks or potential failure.
- Check for Compatibility: Make sure the compression fittings are compatible with the specific type and size of your PEX pipe.
By following these steps, you can install PEX compression fittings securely, ensuring a reliable and long-lasting connection for your plumbing system.
View more:https://www.ifanfittings.com/
Standard:ASTM F1974，ASTM F1281，CSA B137，DIN 16836，GB18997，ISO 21003.It is their standard,so it product is safety and Professional.
View more:https://www.ifanfittings.com/
